IRIG Timecode Generator
IRIG Timecode is the RCC standard used to timestamp video, film, telemetry, radar, and other data collected at test ranges.
Our IRIG Timecode Generator supports A130, A132, A133, B120, B122, and B123 formats.
1-PPS timing strobe
Outputs programmable "n" pulses per second, locked to GNSS (user selectable) timing systems; active edge programmable; typical voltage level 0 to 2 volts on 50 Ohm load; 10 nanosecond phase jitter.
Event Marker
Accepts and time tags events with 10 nano seconds resolution; programmable active edge; input level 3.3 volt CMOS with 5 kOhm pull up resistor.
External Frequency Input/Output
In the Input mode it locks the internal oscillator of the GNSS receiver to an external clock (usually Cesium or Rubidium) connected to the receiver.
In the output mode it locks the internal 20 Mhz oscillator of the GNSS receiver to the GNSS timing system (user selectable) and outputs the frequency via an RF connector.
CAN (Controller Area Network)
CAN 2.0A/B with maximum speed of one megabit per second. It includes all hardware and software.
RS232 Serial Ports
In receiving it accepts ±3 to ±25 volts. In transmitting typical levels are ±5.5 volts. Maximum speed: 460.8 kbps. The low speed version of RS232 Port A (9600 baud) is standard in all of our products.
RS422 Serial Port
RS422 is an interface which supports balanced and differential Point-to-Point and Multi-Drop data transmission at data rates of up to 460.8 kbps. With maximum cable length of 500 meters, speed of about 200 kbps could be achieved.
USB Port (TRIUMPH-1, TRIUMPH-4X)
Compliant with specification 2.0, can act as a vendor specific device at Hi-Speed rate of up to 480 Mbit/s or at Full Speed rate of up to 12 Mbit/s.
USB Port (OEM Boards)
Compliant with specification 2.0, can act as a vendor specific device at Full Speed rate of up to 12 Mbit/s.